 Largemouth Bass
| |||||||||
Custom Search
Fishing
Camping
Hunting
General
Books/VideosMagazines Supplies Posters |
Fishing a Plastic Worm
Skipping – This is the only method to get under overhanging branches. You need a spin casting or spinning rig because a level wind reel just doesn’t skip well. Make a flat hard cast onto the water’s surface so that it will make a low skip. This will reach bass hangouts impossible to attain in any other way. Ripping – This will surprise reluctant bass to strike a worm. Let the worm settle to the bottom and lie there for about 20 seconds. Reel slack out of the line and pick up the worm with a long, sharp upsweep of the rod tip. Let it settle to the bottom under tension as you slowly lower the rod tip. Repeat for three or four rips. Strikes will come. Drift trolling – move to the head of a deep hole and let the wind carry you quietly across the lake while your worm crawls across bottom cover. Raise and lower the worm as it contacts bottom. Pickups usually happen as the worm is being pulled off the cover. Flyrodding – Fill a single action flyreel with backing and about 50 yards of 10-pound monofilament. Rig a six-inch worm weedless and add a small split-shot ahead of the hook so it will sink slowly. Either flip or flat-cast the worm into every pocket you see and feed it line as it slowly settles to bottom. Keep the flyrod tip low so that you can make a long, sweeping strike when you feel a bass inhale the worm. This is practical in ponds, lakes or streams. Worm Rig One of the biggest problems with fishing a worm is the inability to sense strikes. Usually the inability to sense them is due to a sinker that is too heavy and a line that is too thick. Use a variable buoyancy worm using lead strip sinkers. Here are some advantages:
Make sure to use no heavier than 8-pound mono line – preferably 6 pound. Weather Matters In the early spring and fall bass will smash top water lures such as floating propeller types and poppers. They are also likely to take surface lures when found in shallow water, such as along shorelines near overhanging trees. As the temperature rises and the bass are in the cooler, deeper holes, change your technique. You need something to dredge the bottom. The plastic worm is ideal for this, even the most sluggish bass will respond when you drag one slowly past its nose. Crank baits When fishing a tidal river for bass, cast crank baits near the mouths of tiny feeder streams on the falling tide. Bass hang out where the water depth drops off, waiting for crayfish, crabs and minnows to be washed out. Bait One of the best baits for small mouth bass in rivers is the hellgrammite, the larva of the Dobson fly. Gather these from beneath rocks in shallow riffles with a mesh net or seine. Fish them on No. 4 or 6 fine-wire hooks, drifting them naturally through pools and runs below rapids. A Trick Most Bass Fishermen Don’t Know First and foremost, most bass fishermen are not aware of The Evening Secret which is a special device that will bring feeding fish swarming to your location on the water. It works like a charm. Cast a worm over a limber branch and reel it back so that its tail just touches the water. Then jiggle the rod tip, making the worm squirm and wriggle just above the surface. Bass will often leap right out of the water to snatch it. Night Fishing Many anglers have the idea that bass do not see well at night and won’t strike. Although it is true that bass cannot see well at night, but they have an amazing ability to pick up disturbances on the water and hone in on unsuspecting bait. Given this, lures that vibrate will cause the most underwater disturbance and are most effective. You can also drill a small hole in balsa or plastic lures to place small BB’s in them to make some noise. by: Frank Faldo About The Author Copyright 2005 EveningSecretFishing.com Long-Time Fisherman and President of Evening Secret Fishing http://www.eveningsecretfishing.com/specialsecret/Bass_Tips.php -- Largemouth Bass Fishing ArticlesDon't see what you are looking for? | |||
| ||||
